When your ieGeek Cam displays a flashing red light accompanied by a steady blue light, it typically indicates a connectivity issue or that the camera is in the process of establishing a network connection. Here are the steps to troubleshoot this issue effectively:

1. Power On the Camera: Ensure that the camera is powered on. If it is in sleep mode, wake it by clicking the power button.

2. Check Your Network Connection: Ensure that the camera is within range of your Wi-Fi router. Relocate the camera closer to the router if necessary.

3. Reset the Camera: Perform a hard reset on the camera. Locate the reset button, usually a small pinhole, and use a paperclip to press and hold it for 5-10 seconds until the red light flashes rapidly. Then release it to reset the camera.

4. Re-add the Camera to the App: Open the ieGeek app on your smartphone. Follow the prompts to add the camera back to your device. The blue light should begin to flash during this process.

5. Check for Firmware Updates: Within the app, check if any firmware updates are available for your camera. Keeping the firmware up to date can resolve connectivity issues.

6. Inspect the Power Supply: Make sure that the camera is receiving power adequately. If the charging indicator light is solid red, it is charging; a blue light indicates a full charge.

7. Troubleshoot Signal Failures: If the red flashing light persists even after resetting, it may signify a network failure or that the camera could not connect to Wi-Fi. You may need to provide your camera's serial number to customer support for further assistance.

Implementing these steps should help you resolve the issue with your ieGeek Cam's indicator lights.

For further details on troubleshooting techniques, you can refer to these resources: learn more - learn more - learn more.